A used car can be a smart buy or an expensive mistake, and the difference often comes down to what you check before handing over the money. A clean, shiny car can still hide flood damage, a rolled-back odometer or a failing transmission. This checklist walks you through the three checks that matter, in the order to do them.
Step 1: Check the car’s history before you visit
Ask the seller for the 17-character Vehicle Identification Number (VIN). It is on the driver’s side of the dashboard (visible through the windshield), on the driver’s door jamb and on the title and registration. Then:
- Get a vehicle history report. The Federal Trade Commission recommends getting one before you buy. The U.S. Department of Justice’s National Motor Vehicle Title Information System (NMVTIS), at vehiclehistory.gov, lists approved providers whose reports show title brands such as salvage, junk or flood, plus odometer readings and insurance total-loss records. Reports cost a few dollars. Commercial reports can add accident and service records.
- Check for open safety recalls by entering the VIN at nhtsa.gov/recalls. Recall repairs are free at a franchised dealer, but make sure they are done.
- Compare the VIN on the dashboard, door jamb and paperwork. They must match.
A history report is not a guarantee. As the FTC points out, it may list accidents and flood damage but usually not mechanical problems, and not every incident gets reported. That is why steps 2 and 3 still matter.
Step 2: Inspect the car yourself
View the car in daylight, on a dry day if possible, and with the engine cold so you can see how it starts. Work through it systematically. Our free Vehicle Inspection Checklist covers 60+ points and builds a report of anything that needs attention. The essentials:
Exterior
- Look along each side for ripples, mismatched paint or uneven gaps between panels, which can indicate accident repairs.
- Check for rust, especially around wheel arches, door bottoms and underneath.
- Check all four tires for tread depth and uneven wear. Uneven wear can point to alignment or suspension problems. Our guide to checking tire tread depth explains how.
- Test every light: headlights, brake lights, turn signals and reverse lights.
Under the hood
- Look for leaks, fresh oil spray or wet patches.
- Check the oil: very dark, gritty or milky oil is a warning sign.
- Check coolant and brake fluid levels, and the condition of belts and hoses.
- Note the battery’s age if there is a date sticker.
Interior
- A musty smell, damp carpet, fogged lights or silt under the seats can indicate flood damage.
- Test the air conditioning, heater, windows, locks, seat adjusters and infotainment.
- When you turn the key to “on”, warning lights should briefly illuminate and then go out once the engine starts. A warning light that never comes on at all can mean a bulb was removed to hide a fault.
- Check that the wear on the pedals, steering wheel and seat matches the mileage.
The test drive
Drive for at least 20 minutes on a mix of roads, including highway speeds if you can.
- The engine should start easily from cold and idle smoothly.
- Gear changes should be smooth with no slipping, clunks or delays.
- The car should track straight and stop straight, with no grinding, pulsing or pulling under braking.
- Listen for knocks over bumps and whining or humming at speed.
- Check that the temperature gauge stays steady.
Step 3: Get an independent pre-purchase inspection
The FTC recommends an independent inspection by a mechanic you choose, even if a dealer has inspected or “certified” the car. A mechanic can put the car on a lift, read stored trouble codes, check for frame damage and spot worn parts you cannot see. It typically costs a modest fee and can save thousands. If a seller refuses to allow an inspection, treat that as a serious red flag.
Check the paperwork
- Title: the seller’s name should be on it, and it should not be branded salvage, rebuilt or flood unless that is clearly disclosed and priced in.
- Liens: make sure any loan on the car will be paid off and released.
- Service records: regular oil changes and maintenance are a good sign.
- Dealer sales: the FTC’s Used Car Rule requires dealers to display a Buyers Guide on each used car, stating whether it comes with a warranty or is sold “as is”.
Red flags that mean walk away
- The seller will not provide the VIN or allow an independent inspection.
- VINs do not match, or the title is not in the seller’s name.
- Signs of flood damage or major frame repairs.
- Pressure to decide immediately or pay in cash only.
Plan the cost of ownership
Before you commit, work out the real monthly cost. Our Car Loan Calculator shows the payment and total interest for different terms, and the Fuel Cost Calculator estimates what your regular driving will cost in fuel.
Sources
- Federal Trade Commission, “Buying a Used Car From a Dealer” and vehicle history report guidance (consumer.ftc.gov)
- U.S. Department of Justice, National Motor Vehicle Title Information System (vehiclehistory.gov)
- NHTSA recall lookup (nhtsa.gov/recalls)
This guide is for general information and is not legal or financial advice.