A dead battery is one of the most common reasons drivers call for roadside help, and in many cases a jump-start gets you moving again in a few minutes. Done in the wrong order, though, jumper cables can cause sparks, damage electronics or even make a battery explode. Here is the safe way to do it, step by step.
Before you start
- Check your owner’s manual. Some cars, especially hybrids and many newer models, have dedicated jump-start terminals under the hood or special instructions. Follow them if they differ from the general steps below.
- Look at the dead battery. If it is cracked, leaking, bulging or smells strongly of rotten eggs, do not jump it. Call for roadside assistance.
- Never jump a frozen battery. A battery that has frozen can rupture when current is applied.
- You need: a set of jumper cables in good condition (no exposed wire) and a car with a healthy battery of the same voltage, which is 12 volts for almost all passenger cars. Gloves and eye protection are a good idea.
Step-by-step: how to jump-start a car
- Position the cars. Park the donor car close enough for the cables to reach, without the two cars touching. Put both in Park (or neutral with the parking brake on) and turn both engines and all accessories off.
- Identify the terminals. The positive terminal is marked “+” and often has a red cover. The negative terminal is marked “−”. Clean off heavy corrosion if it prevents a good connection.
- Connect red to the dead battery’s positive (+).
- Connect the other red clamp to the good battery’s positive (+).
- Connect black to the good battery’s negative (−).
- Connect the last black clamp to unpainted metal on the dead car, such as a bolt or bracket on the engine block, away from the battery. Do not clamp it to the dead battery’s negative terminal. A battery can give off hydrogen gas, and AAA advises making this final connection away from the battery so any spark happens at a safe distance.
- Start the donor car and let it run for a few minutes to put some charge into the dead battery.
- Try to start the dead car. If it does not start, wait a few more minutes and try again. If it still will not start after a few attempts, stop: the problem may not be the battery.
- Remove the cables in reverse order: black from the metal ground, black from the good battery, red from the good battery, then red from the formerly dead battery. Keep the clamps from touching each other or any metal while you work.
After the jump: keep the engine running
Drive the car for at least 20 to 30 minutes, ideally at steady speeds rather than in stop-and-go traffic, so the alternator can recharge the battery. Avoid turning the engine off right away. If the car will not restart later, the battery may not hold a charge or the charging system may be faulty.
Using a portable jump starter
A portable jump starter (booster pack) means you do not need a second car. Follow the device’s instructions, but the usual sequence is: make sure the pack is off, connect red to the dead battery’s positive terminal, connect black to unpainted metal on the engine, switch the pack on, then start the car. Turn the pack off before removing the clamps. Keep the pack charged; many lose charge slowly in storage.
Common mistakes to avoid
- Reversing the cables. Connecting positive to negative can cause a large spark and damage fuses, the alternator or electronic modules.
- Letting clamps touch while any cable is connected.
- Leaning over the battery while making connections.
- Revving the donor engine hard. A normal idle is usually enough.
- Jumping over and over. If you need a jump every few days, the battery or charging system needs to be tested.
Why did the battery die?
Common causes include lights or accessories left on, short trips that never fully recharge the battery, extreme heat or cold, a parasitic drain from a faulty component, a weak alternator, or simply age. Most car batteries last about three to five years. Read our guide to the signs of a dying car battery to see whether yours needs replacing.
Heading out on a long drive? Add jumper cables or a charged jump starter to your kit. Our Car Safety Checklist builds a custom list for your trip.
Frequently asked questions
How long should I leave the cars connected?
Let the donor car run for a few minutes before trying to start the dead car. If the battery is deeply drained, a little longer can help.
Can jump-starting damage my car?
Done correctly, it is very low risk. Damage usually comes from reversed polarity or sparks. Always check your manual, especially on hybrids and EVs.
Can I jump-start a car in the rain?
It is possible with care: keep the cable clamps dry and off the ground, and make sure you have firm footing. If conditions are severe, call roadside assistance.
Sources
- AAA, “How to Jump a Car Battery Safely” (AAA Northeast) and AAA battery guidance
- Edmunds, “How to Jump-Start a Car”
This guide is for general information. Always follow your vehicle manufacturer’s jump-start instructions.